Table des Matières
Publicité
INSTALLATION INSTRUCTIONS
3C.Surface and conduit mounting: see FigC
Use Mounting plate [8] as template to mark mounting hole
locations and drill 3/16" diameter pilot holes. Partially install
Mounting screws (Hardware included for mounting to wood
surfaces only) Note: Assure that fixture is mounted onto
structurally sound surface that will support the weight of
the fixture.
Remove access panel [14] Note: a safety tether will
temporarily hold the panel. Thread house supply wires
through Mounting plate and fixture neck or, if conduit is
used, through Conduit excess hole (13) into fixture wiring
compartment.
Align keyhole and slots on Mounting Plate with the three
partially installed Mounting Screws and tighten the Mount
ing Screws to secure fixture.
Use wire nuts to make wiring connections inside wiring
compartment as outlined in instructions in step 4.
Push wire connections into fixture compartment and
re-install access panel.
4. CAUTION: WIRING AND FIXTURE OPERATION Note: Make sure power is turned off!
Use Wire Nut to connect the house supply ground wire (copper) & the fixture ground (copper) wire.
Note: If house wiring does not include a ground wire, consult your local electrical code for approved grounding methods.
Use Wire Nuts to connect the black fixture wire to the black power supply wire and the white fixture wire to the white
(neutral) house supply wire.
For proper connection, place wire nut over wires
and twist clockwise until tight.
5. Turn on electricity at fuse or circuit breaker box and verify success of installation.
Note: Adjust photocontol so that the window is fully open
6. Apply silicone caulking (not included) around the perimeter of the back of the
fixture where it contacts the mounting surface for moisture seal.
This LED light provides low maintenance service with no bulbs to change. Clean surfaces with mild soap and water. Do not
use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
WARNING: There are no user serviceable parts inside fixture.
INSTALLATION FIGURES - FIGURES D'INSTALLATION
13) Conduit
access Cap
12) Safety
Tether
Page 6
FIGURAS DE LA INSTALACIÓN
6) 1/2" Screw
8) Mounting Plate
7) Gasket
1) LED Light Fixture
14) access panel
15) photocontrol
Fig C
Publicité
Table des Matières
