Table des Matières
Publicité
INSTALLATION INSTRUCTIONS
FIXTURE PACKING LIST
Description
1) LED Light Fixture................................... ....................... 1
2) Crossbar* ......................................................................... 1
3) Threaded Pipe* ................................................................. 1
4) 1/2" #8 Screws* ................................................................ 2
5) Backplate* ........................................................................ 1
6) 1/2" #8 Screws *(stainless steel) ...................................... 4
7) Gasket* ............................................................................ 1
8) Mounting Plate* ................................................................ 1
9) Wire Nuts* ........................................................................ 3
10) Decorative Nut* ................................................................ 1
11) Set Screws ...................................................................... 2
12) Safety Tether ................................................................... 1
13) Conduit access Cap............................. ........................ 1
14) Access Panel.................................. ............................. 1
15) Adjustable Photocontrol................................... ............ 1
16) Allen Wrench*.................................. ............................. 1
*Contained in parts packs
Mounting Hardware Included
Silicone Sealant required
1. Remove fixture components and parts pack. Check that
all parts are included.
2. Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power.
Note: NOT suitable for use with dimmers, motion sensors
or other remote devices.
Note: This Fixture is intended for Wall mount above
6ft (1.8m) only - DO NOT USE AS UPLIGHT
This fixture is designed for multiple installation options:
3A. Installation to round or rectangular recessed and
round surface mount j-box: see FigA1 & A2
Remove Mounting Plate [8] (shown in Fig B) and attach
Backplate [5] (see Fig A1).
Install Crossbar [2] with Threaded Pipe [3] to standard
recessed outdoor wet location junction box using two 1/2"
screws [4] (see Fig A2).
Use wire nuts [9] to make wiring connections as outlined in
step 4.
Push wire connections into j-box and align Backplate with
the Threaded Pipe. Push Backplate close up to wall and
secure with Decorative Nut [10] Note: make sure not to
pinch any wires.
3B. Installation to extension arm (sold separately): See FigB
Loosen Set Screws [11] on bottom of fixture neck (with
included allen wrench) and remove access panel [14] (see
FigC) of LED Light Fixture to access wiring compartment.
Note: a safety tether will temporarily hold the panel while
wiring fixture.
Align hole in neck of LED Light Fixture with extension arm,
thread house supply wires extending from arm through
neck into fixture wiring compartment and slide LED Light
Fixture onto arm being careful not to pinch any wires.
Make sure fixture is level and tighten Set Screws to
secure. Follow fixture wiring instructions contained in this
Inst Sheet in step 4.
INSTALLATION FIGURES/FIGURES D'INSTALLATION
Quantity
Fig A2
3) Threaded Pipe
2) Crossbar
11) Set Screw
Page 4
FIGURAS DE LA INSTALACIÓN
REQUIRED TOOLS
HERRAMIENTAS REQUERIDAS
OUTILS REQUIS
6) 1/2" Screws
5) Backplate
7) Gasket
9) Wire
Nuts
4) 1/2" Screws
Mounting Arm
(sold separately)
14) access panel
Fig A1
1) LED Light Fixture
10) Decorative Nut
Fig B
Publicité
Table des Matières
