Pattfield PE-1200 Mode D'emploi page 87

DEPTH GAUGE
1 Loosen the auxiliary handle
the depth gauge into the auxiliary han-
dle 3.
Caution! Make sure the tool is
switched off and unplugged.
DUST COVER
1 Attach the dust cover to the chisel or
drill.
Caution! Make sure the tool is
switched off and unplugged.
HAMMER FUNCTION
1 Press the locking button and set the
top hammer-drill/ hammer switch
hammer .
Caution! Only set operation modes
while the aplliance is switched off.
HAMMER-DRILL FUNCTION
1 Press the locking button and set the
top hammer-drill/ hammer switch
hammer-drill
Caution! Only set operation modes
while the aplliance is switched off.
DRILL FUNCTION
1 Press the locking button and set the
top hammer-drill/ hammer switch
hammer-drill .
Caution! Only set operation modes
while the aplliance is switched off.
3 and slide 2 Set the desired clearance of the depth
gauge and tighten the auxiliary handle
screw securely.
2 Use the dust cover to prevent dust from
falling on you or the tool when perform-
ing overhead drilling-operations.
2 Set the rear hammer-drill/ drill switch
7 to to hammer-drill
2 Set the rear hammer-drill/ drill switch
7 to to hammer-drill .
2 Set the rear hammer-drill/ drill switch
7 to 6 to drill .
6
.
6
DE 87