Package Contents; Rear View With Connections - Grundig GML-1912M Manuel D'utilisation

If the power supply cord, that came with your monitor, is to be connected to the PC
instead of the wall outlet, this equipment is to be used with UL/TUV approved
computers with receptacle rated 100-240 V AC, 50/60 Hz, 2.0 A (minimum).
Check the monitor specification carefully. This GRUNDIG monitor has a 1280 x 1024
resolution and works with both PAL and NTSC signal modes. This GRUNDIG monitor is
for 24/7 security purposes; therefore, the environmental specifications such as the
operating temperature and the voltage needed have to be maintained at all times.

3. Package Contents

These parts are included:
- LED Monitor
- Power Cord
- D-Sub 15-pin VGA Connector Cable
- Owner's Manual

4. Rear View with Connections

AC: Connect the power cord that is included in the package.
AUDIO OUT / AUDIO IN: Please use the 3.5 mm jack to transmit audio signals for VGA
mode.
AV1-OUT: Here you can pick off the signal of the BNC input and make it available for
other devices. If no cable connected, the monitor automatically sets a 75 Ω resistance.
AV1-IN: Connect a video source with coaxial cable (with Composite Video Signal) to the
BNC connector.
AV2-IN: Connect a video source with coaxial cable (with Composite Video Signal) to the
BNC connector.
VGA: Connect the monitor with the VGA cable that is included in the package.
HDMI (High Definition Multimedia Input): Here you can connect a monitor with an HDMI
cable (the cable is not included in the package).
NOTE: HDMI includes not only the image transfer but also the ability to transmit audio.
English 3