Machine Information; Technical Specifications - VONROC HA501AC Traduction De La Notice Originale

EN
• Prevent damage of the heating element. Do not
lock or block the mouth piece;
• Do not leave the appliance when switched on;
• Do not use the appliance for drying hair or for
drying living human beings in general;
• Do not use the appliance in a bath, above water
or in spaces where easy inflammable liquids are
used.
This appliance operates at a temperature of
600 degrees without visible signs of this
temperature (no flames), still there is a
chance of fire risk. Watch out for the hot air
stream from the mouth piece. This air
stream can cause burns.
When operating the appliance
• If you are going to use the hot air gun, vapours
and gas can be released during a short time.
This can be harmful for your health. Asthmatics
can suffer hindrance of it;
• Before connecting the plug to the mains voltage
you have to check if the switch is in position "0";
• Keep the mains lead always away from the
mouthpiece of the hot air gun;
• Keep children and animals away from the appli-
ance if you are using it.
Immediately switch off the appliance when:
• Plug and/or cable are defective or damaged;
• The switch is defective;
• You smell or see smoke caused by scorched
insulation from the hot air gun.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine - Double insulation - You
don't need any earthed plug
6

2. MACHINE INFORMATION

Intended use
This hot air gun is intended for a wide range of
applications including plastic welding, the defor-
mation of material, heat-shrink tubing, removing
material residues or drying paint. It is also suitable
for loosening of adhesive joints and the defrosting
of water lines.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
Weight
IP Class
Position I
Air flow
Air temperature
Position II
Air flow
Air temperature
Position III
Air flow
Air temperature
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
HA501AC
220-240 V~
50 Hz
2000 W
0.66 kg
IP 20
500 l/min
50 °C
250 l/min
400 °C
500 l/min
600 °C
WWW.VONROC.COM