Machine Information; Technical Specifications - VONROC OT502AC Traduction De La Notice Originale

• Inspect the machine and the accessories before
each use. Do not use accessories which are
bent, cracked, or otherwise damaged. If the
machine or one of the accessories is dropped,
inspect the machine or the accessory for damage.
If necessary, replace the accessory.
• Only use accessories that are recommended by
the manufacturer.
• Only use accessories that are suitable for the
application.
• Only use accessories with the correct dimensions.
• Do not use accessories that require liquid cool-
ants. Risk of electric shock.
• Make sure that the accessories are properly
mounted. Do not use adapters or other aids to
mount accessories with another spindle diameter.
• Make sure that the maximum speed for the
accessory is larger than or the same as the
maximum speed of the machine. Refer to the
rating plate on the machine.
• Let the machine run at no load in a safe area
after mounting the accessories. If the machi-
ne vibrates strongly, immediately switch off
the machine, remove the mains plug from the
mains, and try to solve the problem.
• Make sure that the workpiece is properly sup-
ported or fixed.
• Wear safety goggles. Wear hearing protecti-
on. Wear a dust mask. If necessary, use other
protective means, such as safety gloves, safety
shoes, etc. Risk of personal injury.
• Keep bystanders away from the work area. Make
sure that all persons in the work area wear
protective equipment. Risk of personal injury.
• Keep the mains cable away from the rotating
accessory. If the mains cable touches the rota-
ting accessory, your hands or arms may come
in contact with the accessory. Risk of personal
injury.
• Hold the machine by the insulated gripping
surfaces where the accessory may contact hid-
den wiring or the mains cable. If the accessory
contacts a 'live' wire, the exposed metal parts
of the machine can also become 'live'. Risk of
electric shock.
• Do not use the machine while carrying it at your
side. Risk of personal injury.
• Do not use the machine near flammable materi-
als. Risk of fire.
• Beware that the accessory continues to rotate
for a short period after switching off the machine.
WWW.VONROC.COM
Do not attempt to bring the accessory to a
standstill yourself.
• Never put the machine down on a table or a
workbench before it has been switched off.
• Regularly clean the ventilation slots. Risk of
electric shock.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use a extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
Your multitool has been designed for light
sanding, sawing and scraping applications.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Weight
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Vibration (sawing in steel)
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardised test given in EN 60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
EN
OT502AC
220-240 V
50 Hz
300 W
0-23.000 /min
1.21 kg
86 dB(A)
97 dB(A)
3 dB(A)
7.38 m/s 2
1.5 m/s 2
5