Cleaning And Maintenance; Safety Information; Cleaning - CASO DESIGN HW 500 Touch Mode D'emploi

3. Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the appliance by
one hand and use the other hand to lift up the drip tray slightly
to remove it.
2. Empty the water tray and insert it into the original place. Make
sure it is properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10
sec.
4. Remove the old filter and replace it with a
new filter (see fig.). Therefor take out the
filter box, place the new filter and pull it down
from the bottom.
A tank cover B filter box
5. Error code E7
If the appliance stops to operate with a beeping sound and the display shows the error code
E7, it means that there is too little water or no water in the water tank. Please fill in enough
water into the water tank immediately.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device incorrectly
and to ensure trouble-free operation.

15.1 Safety information

Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the unit, cord or plug in water or other liquids and do not place in the
dishwasher.
► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.

15.2 Cleaning

1. Remove the plug from the outlet and let the device cool down.
2. To maintain the performance of the device, descale the appliance at least once a month. If
you use a CASO water filter and change it as regular as described in chapter14.2 you do
not need to descale the appliance.
C filter
Attention
29