Overheating Protection & Reset; Design And Function; Overview - CASO DESIGN HW 500 Touch Mode D'emploi

 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.
12.7 Overheating protection & reset
The appliance is equipped with an overheating protection facility.
If the temperature of the appliance exceeds the critical limit the
appliance shuts off further power supply for safety reasons.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.

13.1 Overview

► Warning symbol: hot steam.
► Caution hot steam can escape at device. Risk of burns.
1 drip tray
2 cover of drip tray
3 main body
4 spout
5 control panel
6 tank cover
7 tank
8 base
By pressing the reset button (1) the
appliance can be reactivated.
Unplug the device before reset. When
the device is only producing cold water
please press reset button.
Please use enclosed reset-key for the
reset-button.
Warning
26