Norsup 7021075 Mode D'emploi page 25

6.2.1 button
Press to start the heat pump unit, the LED display shows the desired water temperature for 5 seconds, then
shows the inlet water temperature and the operation mode.
Press to stop the heat pump unit and show "OFF"
Notice : During the parameter checking and setting, press the
Press again to turn on/off the machine.
6.2.2 button
Automatic mode:
Press for 5 seconds to switch to automatic mode.(default:Smart mode)
Press for 5 seconds again to exit automatic mode and switch to heating mode(default:Smart mode)
Note:Under Automatic mode, it is useless to set parameter P1 .
Operation logic of Auto Mode:
Set water temperature
(Tset)
Tset (eg: 28℃)
Tset (eg: 28℃)
6.2.3 and
Clock/unclock the display:
Hold and
Water temperature setting :
or
Press
Parameter checking :
Press first, then press
Current water in
temperature
(Tset +2℃)
Tset +2℃ (eg:30℃)
Tset-2℃(eg: 26℃)
button
for 5 seconds to lock/Unlock the display.
to set the water temperature directly.
to check the " User parameter from d0 to d11
to quick-exit and save the current setting .
Current working
mode
Heating mode
Cooling mode
22
After 3 minutes or
above, it will switch to
Cooling mode
Heating mode