Key Description; Instruction For Use - WUNDER CR Manuel D'instruction

EN
DO NOT remove the sigils on the device
•
DO NOT short-circuit terminals of the batteries
•
DO NOT throw batteries into the fire
•
ON/OFF: Power ON/OFF Button
ZERO/TARE: Set the zero point for all subsequent weighing.
Tares the scale and memorize the weight as a tare value. Than it subtracts tare value from the current weight
showing net weight.
If the weight is less than 2% of capacity, zeroing is active, if current weight is more than 2% of capacity, tare is active.
When the scale is off, press ZERO/TARE to enter setting mode (to check internal counts and to do calibration)
HOLD/UNIT: pressing it one time it enables/ disables hold function to lock weight.
Pressing it for 4 seconds you can change the weighing unit (kg or lb).
The device use 3x batteries type AA stored on the back side.
To remove batteries cap on the back side slide it to the right, to close it slide it to the left.
In case of extended non-use of the device, please remove all the batteries.
ZEROING: Press ZERO/TARE key to set the zero point, within 2% of the zero range when powered on.
This operation is tipically used when there are no loads on the device, indicated by symbol on the display.
In addition, the device has an auto-zero function to compensate small changes of the indication. For weight
values higher than 2% of the maximum capacity, it will operate tare function.
TARE FUNCTION: If necessary, set zero point by pressing ZERO/TARE key.
Place a container on the hook, the value will be displayed.
Press ZERO/TARE to tare the scale and memorise the container weight as tare value. Tare indicator will light up.
Adding pieces in the container, will be displayed their net weight, already shown without container weight.
It's possibile to do a second tare operation if the container is changed.
By removing the container from the hook the indication will be negative. If tare function has been done before
removing the container, the negative value includes the weight of the container and all the pieces placed insede.
The zero indicator will be ON because the hook is back to the same condition before ZERO/TARE key was last
pressed. You can press ZERO/TARE key again to escape TARE mode.
Note: for weight values lower than 2% of the maximum capacity, will be operated zero function.
This means that tare weight can't be lower than 2% of the maximum capacity.
DYNAMOMETER CR REV. 01 del 13/12/2018

3. KEY DESCRIPTION

4. INSTRUCTION FOR USE

8