habitat et jardin VITO 1 Mode D'emploi page 5

Do not use in puddles, snow or slush. Do not use in places where you may get sand,
mud or water on the hoverboard.
Do not modify the hoverboard in any way. If you need to repair the hoverboard, only
use original parts.
USING INSTRUCTION
Charging
The hoverboard must be charged fully prior to initial
use. The hoverboard must then be charged at least
whenever only one block is shown on the battery
indicator.
If necessary, allow the battery to cool before charging.
Use the charger provided only.
Charge the battery indoors at a temperature
between 0 and 40°C.
Open the cover over the charging socket on the
hoverboard. Check that the charging socket is
completely dry.
Insert the plug from the charger into the charging
socket. It can only go in one way. Plug the charger
into the main socket.
The indicator light will show a red light whilst the
hoverboard is charging. Once the hoverboard is
fully charged after about 2 hours, the indicator light
on the charger will turn green. Unplug the charger
from the socket immediately, otherwise the
capacity of the battery may be reduced.
The hoverboard must not be turned on or used
while it is connected to the charger.
Use
Make sure that the hoverboard board is charged
before use.
Stand behind the hoverboard board. Switch the
hoverboard board on by pressing the on button.
Place one foot on the hoverboard's pedal The
hoverboard lights up and the balance system is
5