Chapter 5 | Change Of Moisture Curve / Pressing Force - DRAMINSKI HMM Mode D'emploi

Change of moisture curve:
• switch on the device (must be in moisture
measurement or temperature measurement mode)
• hold T/M button for about 5 seconds
• the number of the curve on which the device is set
up should appear, e.g. "-1-"
• use MAX (up arrow) and MIN (down arrow) to
select the curve number you would like to use for
moisture measurements
• confirm with T/M button
18

CHAPTER 5 | CHANGE OF MOISTURE CURVE / PRESSING FORCE

Identification of moisture curves regarding
pressing force:
-1- suggested for high pressing force
-2- suggested for middle pressing force
-3- suggested for low pressing force
Note!
Each time you switch on the device you see the
symbol of the curve at which the software is set
up, e.g. "-1-" means moisture measurements are
performed accordingly to curve no 1.
In case of questions contact us at:
phone: +48 89 527 11 30
e-mail: agri@draminski.com