Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FlyCamOne²
Content
Camera
Velcro-pad
Eyelet band
Baseplate
USB-Cable
Servo arm
ATTENTION!
Through a collision at a high speed, the record can be deleted.
ATTENTION!
The privacy of others is protected by law and should be taboo. The recording of third party can be a illegal act. You are responsible for
your acting.
Please Note:
Avoid extreme temperatures.The internal batteries can stand temperatures from -10°C to +80°C (14°F – 176°F)
Installation:
Remove the film protecting the lens. The lens cover is high glossy when removed!
For best results use a SD-Card with 2, 4 or 8GB and a writing speed of 4MB/sec minimum. . The card clicks in when inserted – use a pen for support.
RY
Switch on the Camera and press the release button once; „
"for „Ready"will be displayed. Select the mode by pressing the menu button (3) and
start recording pressing the release button.(2)
Please Note! Before you turn off the cam, make sure you have stopped the video, else the file is lost!
Download the data
Choose „
"and connect the FlyCamOne² with the supplied USB-cable and your PC.
The FlyCamOne² will be displayed as a single drive. Attend that network drives can interfere the FlyCamOne² drive.
Cut the network drives. Of course you can connect the SD-card directly to your pc card reader.
Charge the FlyCamOne²
The charging starts on its own by connecting the FlyCamOne² with the PC. It will take approximately 3 hours to charge the FlyCamOne².
The battery status is indicated in percent below modes as follows:
,
,
. Recharge the cam when "
"is displayed.
The modes
Video recording [
]
The recording takes place with 28 pictures per second (28 FPS) with 640x480 px and a consumption of storage of approx. 50 MB/min.
Recording is indicated by running dots"
". FPS rate can be reduced by a dark or indoor environment.
Video endless [
]
Recording as above – however the free storage (min. 200 MB) of the SD-card is shared and the old part will be overwritten consecutively.
The recording will be stopped not until the shutter button [2] gets pressed.
Publicité
Table des Matières
