Bluetooth - PTEC Pilatus Mode D'emploi

5.8.3 Settings
Scan settings
•
Audio settings
•
5 5 5 5 . . . . 9 9 9 9

Bluetooth

Bluetooth Bluetooth Bluetooth
In Bluetooth mode, Pilatus enters the pairing mode automatically. You can turn on
the Bluetooth of your Bluetooth device and search the radio Pilatus to pairing. When
Pilatus is waiting for pairing, there is a blinking Bluetooth icon at the bottom. If the
pairing is successful, it has a "beep" sound and the Bluetooth icon becomes steady.
Control the music playback from your Bluetooth device.
To unpair from Pilatus, press and hold
press and hold
By default, FM scans stop at any available station. This may
result in a poor signal-to-noise ratio (hiss) from weak stations. To
change the scan settings to stop only at stations with good signal
strength, select Yes after choosing Strong station only?
All stereo stations are reproduced in stereo. For weak stations,
this may result in a poor signal-to-noise ratio (hiss). To play weak
stations in mono, select FM weak reception: Listen in mono only
and then YES.
to unpair Bluetooth.
and choose BT disconnect or
75