PTEC Pilatus Mode D'emploi page 62

choose Push Button/Pin/Skip WPS to connect to the wireless
network.
PBC Wlan setup
•
Push Button Configuration, it is to connect the AP that
supports WPS (Wi-Fi Protected Setup).
View settings
•
View the information of current connected network: Active
connection, MAC address, Wlan region, DHCP, SSID, IP address,
Subnet mask, Gateway address, Primary DNS and Secondary DNS.
Wlan region
•
Select the Wlan region to obtain the optimal Wlan
connectivity: Europe, Canada, Spain, France, Japan, Singapore,
Australia, and Republic of Korea.
Manual settings
•
Choose wired or wireless network connection and enable or
disable DHCP (Dynamic Host Configuration Protocol).
Network profile
•
Pilatus remembers the last four wireless networks it has
connected to, and automatically tries to connect to whichever one
of them it can find.
From here you can see the list of registered networks. You can
delete unwanted networks by turning and pressing the reel or
delete.
Keep network connected
•
on the remote control then choosing YES to confirm
62