Troubleshooting Checklist - Slendertone ABS3 Mode D'emploi

T
ROUBLESHOOTING CHECKLIST
If you have problems getting your
through the following checklist:
When did you last change your GelPads?
Pads need to be changed every 20-30 sessions. Call our support
line below to place an order.
Have you removed all the plastic covers from both the grid side
and the black side of each GelPad?
Remember to keep one set of covers to protect the black side
of the GelPads during storage.
Are the GelPads covering the metal studs?
Double-check the GelPads on your belt to ensure that the grid
side of each GelPad is fully covering the metal studs.
Are the batteries inserted correctly?
The batteries must be inserted in a specific way for the controller
to work (see page 6). If you find any corrosion within the battery
compartment call the support line below for assistance.
Is your controller inserted into the holder properly?
Remove the controller and wipe the holster pin with a dry cloth.
Then re-insert the controller, pushing it until it clicks into place.
Are the GelPads and belt positioned correctly?
Ensure the large, center GelPad is directly over your navel and
that the smaller GelPads are directly between your hip-bones
and ribs.
Still having trouble? Call us toll free on
1-800-551-2443
See www.slendertone.com for GelPads & Accessories
10
3 to work, you should go
SLENDERTONE ABS
English
C
ARING FOR YOUR BELT
The belt can be washed, but you must first remove the controller
and GelPads. Always follow the instructions on the label when
washing the belt.
Never machine wash your belt. Always hand wash it in
lukewarm water. This protects the internal wiring from
damage in the washing machine.You should take care
even when hand washing and never wring the belt to
remove water.
Do not use any bleach when washing your belt.
Do not dry clean your belt.
Do not tumble dry your belt. Dry the belt on a flat surface,
but not on anything hot (e.g. a radiator) as the belt
contains plastic parts. Ensure the belt is completely dry
before use.
The belt must not be ironed.
SLENDERTONE
www.slendertone.com