Publicité
Les langues disponibles
Les langues disponibles
English
moving parts with Teflon spray (dry
lubricant) and rub this in using a soft
cloth.
Fabrics
· All Mutsy fabrics undergo testing, but
if the pram becomes extremely wet, the
moisture can be absorbed by the inte-
rior and exterior fabric and leave rings
behind. To prevent this from happening,
we advise that you always use the rain-
covers during wet weather.
· The lining and the cover can be washed
by hand using a mild detergent in water
no warmer than 30°C.
NB: Do not use a washing machine or
dryer.
· Stains on the inner and outer covers can
be washed using water and a bleach-
free liquid soap. Always treat the entire
surface. Always store a wet pushchair
with its hood tensioned.
· Although the Mutsy fabrics have been
selected with the greatest possible
care and tested for colour fastness, the
material can discolour. Mutsy is not
responsible for any discolouration that
may occur.
Contents of the box
· 1 large frame
· 1 small frame
· 2 seats (number 01 and number 02)
· 2 hoods: 1 hood with a rear flap for the
rear seat and 1 hood without a rear flap
for the front seat
Assembly (1+2)
· Position the large frame with the at-
tachment parts above the universal
attachment point on the frame. Press
down on the duoseat frame until it
clicks firmly into position. Check
whether the duoseat is horizontal and
the red areas in the universal attach-
ment point are fully covered. (1)
· Fasten seat 02 to the small frame by
clicking the 2 front fastening clips into
place on cross connection C. (2a)
· Now place the 2 seats on the large
frame:
- Place the seat with number 01 so that
the 4 attachment clips are above the 2
front crossbars (crossbar A + B). Press
10
seat 01 downwards, so that the clips
are on the crossbars. Now fasten the 4
attachment clips so that they click into
place.
- Place the seat 02 with the 2 attach-
ment clips at the bottom above cross-
bar no. D. Take care to ensure the
metal pins on the duoseat frame are
guided into the recesses in the metal
back adjustment components. Move
the seat 02 so that the fastening clips
are on cross connection D. Close the
two attachment clips until they click
into place.
! You can only position the duoseat
frame on the frame in one direction.
This direction is shown in figure 1.
Removal from the frame (1a)
· Push away from you the two release but-
tons on the universal attachment point
until the duoseat is released from
the locking mechanism. You can now
remove the duoseat frame and seats
from the Urban Rider.
Assembling the hoods (3)
· Position the hoods in the openings as
shown in the drawing. Mount the hood
without a rear flap on seat 01. Mount
the hood with a rear flap on rear seat.
· To remove the hoods, push (L+R) on
the appropriate catch and pull the hood
out of the recesses.
Placing your children in the seats
! Warning: Use a harness as soon as your
child can sit unaided.
· Place your children in the seats and make
sure that the legs of your children are
on both sides of the crotch strap.
· Both seats have a 5-point safety harness.
You operate the safety harness by fixing
all the plastic parts.
· The safety harness can be adjusted by
moving the plastic parts over the belts
and placing them in the desired posi-
tion.
Adjusting the rear seat (4+5)
· You can adjust seat 02 to 4 different
positions. In position 1, 2 and 3, the
2 back attachment clips are fastened
to crossbar D, and the metal pins are
Publicité
