Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 5x40 screws
- 4 M5 nylock nuts
- 4 wide plastic washers
- 2 beleved spacers
Assembly
Length 20 spacers' location
Length 25 spacers' location
If necessary, fix the plate with the supplied beleved spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 4 Ø5 plastic washers
- 2 Ø6, length 20 spacers
- 2 Ø6, length 25 spacers
* The mudguard and number plate support are compatible.
FITTING INSTRUCTIONS
Original tyre Dunlop D218 190/50 ZR 17.
« CAUTION »
« PLATE HOLDER»
ZX 10 R 2004/2005
Publicité
