Charging The Appliance - Panasonic ES2067 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Using nail polish remover, benzine, alcohol, etc. to clean the appliance.
-
Leaving the appliance where it will be exposed to high temperatures or
-
direct sunlight.
Contact an authorized service center if the epilator or the cord get
damaged.
Before use
1. Remove the head while holding the head release button.
2. Push the head until it clicks.
Charging
1. Plug the charger into the epilator
() and a household outlet ().
2. Charge the appliance for
approximately 1 hour. (Charging is
completed when the charging light
blinks.)
The epilator can be used for
approximately 30 minutes after 1 hour charge.
The charge light may not turn on after a few minutes in some cases.
However, it will turn on eventually if you continue charging.
The appliance can be left plugged in after it is fully charged without
deteriorating the battery life.
The recommended charge temperature is 15-35 °C (59-95 °F).
If you use the charger in temperature outside of the recommended range,
the following problems might occur.
The time it takes to charge the appliance increases. (approximately 3 hours)
-
The charger stops functioning.
-
If you use the charger in low temperature, the battery life might be
reduced.
The charger is intended to be correctly oriented in a vertical or fl oor mount
position.
If the shape of the plug does not fi t the power outlet, use an attachment
plug adaptor of the proper confi guration.
6
Changing the head

Charging the appliance

While charging: Red light appears.
After charging is completed:
Blinks once every second.
10 minutes after charging is completed:
Blinks once every 2 seconds.
Abnormal Charging: Blinks twice every second.

Publicité

Table des Matières
loading

Table des Matières