Ermax 8904025 Notice De Montage page 2

Fitting kit
- 2 6×10 screws
- 3 6×15 screws
- 4 6 rubber washers
- 1 M6×20 spacer
- 3 M6 brake nuts
- 1 33 collar
- 3 fixing brackets
Assembly
- Remove one engine/frame fixing screw (see photos).
- Insert the fixing bracket on the screw (do not tighten completely at this stage so that you can adjust the
brackets later).
- Follow the same procedure on the other side.
- Put the 33 collar in place on the right hand side of the frame; below the engine casing by fixing the
M6×20 spacer with a M6×10 screw (see photos).
- Position the belly pan and fix it at the four fitting points (use the last M6×10 screw to fix the belly pan at
the level of the spacer).
- The rubber washers must be against the painted side to protect it.
- Ensure that the belly pan is carefully positioned clear of the exhaust pipes and also that it is high enough
to clear the ground. Adjust the fixing brackets gently until you are happy with the position and then
tighten the four screws of the belly pan and the engine /frame fastening screws.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
GSF 600 BANDIT 1995/2004
ATTENTION
« BELLY PAN »