MTD 490-900-0067 Manuel De L'utilisateur page 7

5. Reinstall the seat springs and
hardware that were removed earlier
in the procedure as shown in Figure
3-6.
Figure 3-6
Assembly - Troy-Bilt Bronco, Troy-
Bilt Pony, Troy-Bilt Horse
1. Flip tractor seat up.
2. Remove seat springs and hardware.
Set aside for re-use.
3. Assemble Support (683-05347) and
Mounting Brackets (789-00425,
789-00424) by using 2 Hex Head
Capscrews (710-3180) and 2 nuts
(712-04063) as shown in Figure 3-7.
Figure 3-7
4. Use two Hex Head Capscrews (710-
0376) and two Nuts (712-04063) to
install the Support assembly on rear
of tractor as shown in Figure 3-8.
Figure 3-8
5. Reinstall the seat springs and
hardware that were removed earlier
in the procedure as shown in Figure
3-9.
Figure 3-9
Assembly - John Deere
1. Flip tractor seat up.
2. Remove pucks from rear of machine
by removing 2 T30 screws per each
mount with the included Torx
Tool (727-05140). Set aside for re-
installation.
3. Assemble Support (683-05347) and
Mounting Brackets (789-00399,
789-00400) by using 2 Hex Head
Capscrews (710-3180) and 2 nuts
(712-04063) as shown in Figure 3-10.
Figure 3-10
4. Use the Torx Tool (727-05140)
to install the 4 T30 Torx Screws
removed in step 2 (not included
in hardware pack) to install the
support assembly to the rear of the
tractor as shown in Figure 3-11.
Figure 3-11
S 3 — A & S
ection SSembly
-U 7
et p