C: Rinsing Area - Nobles QUICK CLEAN 1500 Manuel Opérateur Et Piéces

OPERATION
7. While the cleaning solution is working, use the
brush tool to scrub corners, cove base and heavily
soiled areas (Figure 15).
FIG. 15
C:
RINSING AREA
FOR SAFETY: Do not operate machine unless
safety goggles are worn.
NOTE: Use gulper tool if area is not equipped with a
floor drain.
1. Adjust spray gun to high pressure by pulling spray
nozzle inward (Figure 16).
FIG. 16
2. Activate pump switch. If using gulper tool, press
vacuum/blower switch towards vacuum symbol
(Figure 17).
FIG. 17
12
3. Begin rinsing entire area from top to bottom. Turn
spray nozzle clockwise to pin--point grout lines,
heavily soiled and hard to reach areas (Figure 18).
NOTE: Operating the gun at high pressure will
automatically stop injecting cleaning agent.
FIG. 18
FOR SAFETY: When using machine, do not spray
solution into electrical outlets, switches, fuse
boxes or on electrical appliances.
FOR SAFETY: When using machine, never point
spray gun at a person's face.
4. To operate spray gun at low pressure without
dispensing cleaning agent, turn FORMULA
ON/OFF lever to the OFF position (Figure 19).
FIG. 19
5. If solution tank runs dry while operating, you must
operate spray gun at low pressure to reprime
pump. DO NOT OPERATE PUMP DRY.
6. After thoroughly rinsing entire area, shut machine
off. Wipe off solution hose and return gun to
storage hook.
ATTENTION: Relieve water pressure from spray
gun before disconnecting hose.
Quick Clean 1500 (03- -00)