Dutch originals DO-SV-BTSB6-B Manuel De L'utilisateur page 8

If your TV is attached to the wall, you can mount the device centred on the wall
directly below the TV screen.
Installation must only be carried out by qualified personnel. Incorrect assembly
can result in severe personal injury and damage. If you intend to install this device
yourself, you must check for installations such as electrical wiring and plumbing that
may be buried inside the wall. The installer is responsible for verifying whether the
wall will safely support the total load of the device. Additional tools (not included) are
required for installation. Do not over-tighten screws. Use an electronic stud finder to
check the wall before drilling and mounting.
1) Measure a width of 80 cm (31.5 inches) on the wall.
2) Mark the position of the mounting screws on the wall using a pencil.
3) Drill 2 parallel holes (Ø 7-8 mm each according to wall type) in the wall. The
distance between the holes should be 80 cm.
4) Firmly fix 1 plug into each hole in the wall if necessary.
5) Insert 1 screw into each hole or plug. Leave a 7 to 8 mm gap between the wall and
the screw head. Lift the device over the heads of the screws and slot into place.
Connections
Power connection
Before connecting the power adapter, make sure you have completed all other
connections.
• Prior to use, check that the mains voltage is the same as the mains voltage stated
on the device.
• Plug the power adapter into an electrical outlet.
D
• Plug the power plug of the power adapter into the power socket of the device .
D 8
• The device is now in standby mode.
Making a wireless BT connection
You will need to pair your BT enabled audio player with the device when you use it
for the first time.
• Turn the device ON by pressing the power [ON/OFF] button on the remote
1
control.
• Press the [MODE] button on the device or press the [MODE] button on the
2 2
EN 06