Samsung NE63 8 Serie Manuel D'installation page 12

Connecting the power
CAUTION
You must check voltage after connecting power cord.
Live 1 - Neutral
Live 2 - Neutral
Live 1 - Live 2
Installing a 4-wire conduit
• Aluminum building wire may be used but it must be rated for the correct
amperage and voltage to make the connection. Connect the wires as described
below.
• The wire you use, the location and enclosure of splices, etc., must conform to
good wiring practices and local codes.
1. Loosen the 3 lower terminal screws from the terminal block. Remove the
ground screw and ground plate and retain them.
2. Cut and discard the ground strap. Do not discard any screws.
3. Insert the ground bare wire tip between the range frame and the ground
plate (removed earlier) and secure it in place with the ground screw (removed
earlier).
4. Insert the bare wire (white/neutral) tip through the bottom center of the
terminal block opening.
5. Insert the two side bare wire tips into the lower left and the lower right
terminal block openings.
6. Tighten the screws until the wire is firmly secured (35 to 50 inch-lbs.). Do not
over-tighten the screws since it could damage the wires.
7. Go to Step 5 on page 13 to continue with the installation.
12 English
Install_NE63T8911_AA_DG68-01257A-00_EN.indd 12
120 V
120 V
208 V / 240 V
Ground strap
Ground plate
CAUTION
You must check voltage after connecting power cord.
Live 1
Wire tips
Black
Live 1 - Neutral
Live 2 - Neutral
Live 1 - Live 2
White
Black
Red
Neutral
terminal
Live 2
Ground
White
wire (Green)
Red
120 V
120 V
208 V / 240 V
3/19/2020 4:15:03 PM