Publicité
Les langues disponibles
Les langues disponibles
Safety regulation
•
Installation has to be conform the manual. Disregard or change of installation can
result on serious damages to people and material for which the manufacturer refu-
ses to accept any liability or obligation under warranty.
•
The windresistance of an open umbrella is limited and related of the anchoring.
Movable base are less stable than installation fixed to the ground.
•
The ground anchorage has to be fitted accoriding the related fitting instruction.
Fitting has to be carried out by a specaialist with construction know-how.
•
The umbrella must not be altered or draped with a different material. Stability,
function and/or closing mechanism may deteriorate.
•
Use only original accessory and spare parts from Shademaker.
•
If the wind freshens up the sunshade must be closed.
•
Unattended sunshades must not be left open!
Installation:
•
C) Put mast (5) with support tube (1) onto the flange (eg. base, ground socket)
insert the anchorage screws (19), do not tighten yet. Lift turning handle (3) to turn
the mast, now place the fifth anchorage screw.
•
Slide boom (7) over the elbow (6) and tigthen the four screws (two on each side)
•
Adjust umbrella to the required position and thigthen the anchorage screws (19).
•
D) Hook the metalhook of roof shade rope and mast rope together.
•
A+E) Raise roof shade and slide the set screw (18) through the head fitting (8).
turn shade roof 90° clockwise until the set screw (18) engage in the slot.
•
In case umbrella does not stand vertical, loosen the anchorage screws (19) sligh-
tely and adjust with level screws (20) and tighten the anchorage screws (19) again.
•
Open zipper on protective cover. Slip in the aluminum rod into the pockets next to
the zipper. Protectvie cover can now be lifted over the umbrella easily.
Fix thin aluminum rod with the ring directly on the heel of the zipper.
GB
Publicité
