Publicité
Les langues disponibles
Les langues disponibles
Instruction of Assembly
14. After mounting of net, put a cord in the lower net edge and fix it at ring nuts. Fix net in the lower part of net hoops with plastic
holders (3 units per hoop).
15. To store the goals, loose and fold net hoop brace. Screw fixing wheels into the nuts being in the middle of the crossbar so that
they cannot be lost. Remove ground tubes and fold net hoops.
16. The goals have to be anchored on the hall floor. Therefore a corresponding boring (Pos.11) is installed in each hoop.
Attention:
The nets have to correspond to EN standard 749. The goal can only be used for handball and not for other purposes. Before use
check if all connections are fixed and repeat this later again and again. At any time the goal has to be protected against
tipping. Do not climb on net or goal frame.
Additional remark for:
Indoor handball goals with
„folding net hoops"
„for insertion in ground sockets", art. 113 6513
•
Upright's length (inside dimension) is 2300mm = insertion depth 300 mm. For mounting of screws (Pos. 4) use lengthened
hexagon socket screw key.
•
When concreting the ground sockets do not apply an acceleration mixture or antifreeze, as these adhe-
sives may cause damages to the sockets
!
Art.-Nr. 11 113 6119
A
B
Schnitt A - B
Schulsport · Vereinssport · Fitness · Therapie
11 113 6513
11 115 0911
1 = crossbar
2 = upright
3 = safety system net holder (German
Registered Patent)
4 = cast corner joint
5 = net hoop supporting angle
6 = net hoop hinge
7 = net hoop
8 = net hoop brace
9 = boring for net hoop brace
10 = boring for net supporting device-top
11 = boring for goal anchoring according to
German Industry Standards
12 = boring for net supporting
device-bottom
13 = boring to take up ground tube
14 = ground tube
15 = screw socket for ground tube
5
Publicité
