Trouble Shooting - Dexter power S1T-YH-13B Consignes De Sécurité

Suspected malfunctions are often due to causes that the users can x themselves.
Therefore, check the product using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described in these instructions!
All further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly quali ed specialist if you cannot solve the
problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
result
Possible cause
1.1. Not connected to the
power supply
1.2. Power cord or plug is
defective
1.3. Another electrical defect
in the product
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e. g.
generator) has too low
voltage
2.3. Air vents are blocked
3.1. Sanding belt is worn
3.2. Sanding belt not
suitable for work piece
material
26

8. TROUBLE SHOOTING

Solution
1.1. Connect to the power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2.1. Use a proper extension
cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Replace with new one
3.2. Use proper sanding belt
EN