The installation and remove of belt
warning: Make sure the machine is turned o and unplug the power cord before install or
remove the belt.
Please pull up the Clamp lever just above the tracking adjustment knob to release the tension
on the belt, Silde out the belt to be replaced,then re t the requirede belt over the rear and
front rollers.
Belt adjustment path
Check that the sanding belt is running centrally before using. Turn the machine with the belt
facing the operator, Turn the tracking adjustment knob either clockwise or anti-clockwise to
adjust the belt tracking until the sanding belt is running centrally.
Connect the dust bag
This machine is tted with a dust extraction outlet and collection bag. We recommend that
this facility is used at all times, as well as using an approved face mask. It can make the work
cleaner. Fixed the outlet, and then t the dust collection bag onto the dust extraction outlet.
Sanding operation
If the operation may occur during operation the work piece is moved, Please x the work
piece with clamps.
When open or stop the machine, do not let the tool contact with the work piece. Otherwise, it
will result the damage of sander belt or make the machine out of control.
When using the machine operation, we should be careful to avoid any part of the body or
come into contact with any of the items around machines or belt.
Hold the machine with both hands and assume a balanced posture. Press the On/O trigger
switch and allow the motor to reach full speed. Hold the machine parallel to the work piece.
Gently bring belt contact with the work piece. Do not force tool. Use the correct tool for your
application. The correct tool will do the job better and safer at the rate for which it is
designed.
WARNING! During operation ne dust will be generated!
Some dusts are highly in ammable and explosive!Do not smoke during operation,
keep heat sources and open ames out of the working area!
Always use a dust extraction system and wear a dust mask to protect yourself
against hazards resulting from ne dust!
24
6. OPERATION
EN