Maintenance; Filter Replacement; Routine Checks - Dimas PP 455E Mode D'emploi

Operator's Manual PP 455E

Maintenance

Oil change hydraulic unit
There is a magnetic plug on the underside of the tank for
draining the hydraulic fluid. Clean the magnet.
WARNING!
Remember that oil can pose a hazard to
health and the environment.
Open the screw cap on the tank and fill with hydraulic oil
with a viscosity of 68. Make sure that the fluid level is
about 10 mm below the max. mark on the level indicator.
About 16 litres of hydraulic fluid is required when
changing.

Filter replacement

To change the filter, remove the tank cap after loosening
the twelve screws. Loosen the three screws for the filter
housing cover and remove it as well. Lift out the old filter
cartridge and press in the new one, making sure it
engages with the end of the tube in the bottom of the
housing.
Service
After 100 hours of operation the message "Service due" is
displayed. The power unit should then be left with an
accredited DIMAS dealer for servicing.

Routine checks

Regularly check:
The hydraulic fluid level in the hydraulic power unit, to
make sure it lies between the marks on the level glass.
Check the tyre pressures.
Any abnormal noises.
Maintenance
English - 29