Assembly Instructions - Kobalt SGY-AIR87TZ Mode D'emploi

ASSEMBLY INSTRUCTIONS

Read and follow all directions before assembly or use
The life of this product and the efficiency of its
operation depend upon the knowledge of its
construction ， usage and maintenance (See Figure 1.
Not all accessories shown are included).
1. Take out spray gun and put on paint cup
(see Figure 2)
2. Connect air tube to air intake connector from air
compressor; set pressure to 43 psi. Fully open air
adjustment knob and adjust the spray pattern
adjustment knob to proper range (See Fig 3. Oil and
water extractor and air compressor not included.)
1
2
3
6
Gravity Feed Cup
Fluid Adjustment Knob
Air Inlet
Atomization
Oil and
Pressure Gauge
Water
Extractor
Air Hose
Spray Pattern Adjustment Knob
Fluid Adjustment Knob
Air Adjustment Knob