Button Functions; Setting The Date And Time - Brandson Equipment 301518 Mode D'emploi

Mount the sensor unit on a wall using the recess on the rear side. Alternatively,
you can place the sensor unit also at a location that is protected from direct ex-
posure to sunlight and rain. Subsequently, place the main unit with the stand on
a flat surface.
If the weather station cannot produce a signal with the sensor unit within 7 min-
utes, place the main unit and sensor unit closer together. Press and hold the "CH"
button on the rear side of the main unit for approx. 5 seconds. Then the main unit
tries to reconnect to the sensor unit again.

7 Button functions

Button / Action
Press and hold the "Time"
button for 3 seconds
Press the "ALM" button
Press and hold the "ALM"
button for 3 seconds
Press the "UP" button
Press the "DOWN" button
Press the "SNZ" button
Press the "CH" button
Press and hold the "CH"
button for 3 seconds

8 Setting the date and time

To set the time and date, keep the "TIME" button on the rear side of the main
unit pressed. You can make the desired settings using the "UP" and "DOWN"
buttons. Confirm your setting with the "TIME" button and continue with the next
setting item.
16
Function
Time setting
Switch between Alarm 1, Alarm 2 and Standard
mode
Alarm settings
Turn alarm function on or off
Switch between °C and °F
Switch on backlight for 5 seconds
Switch between CH1, CH2 and CH3
Reset the current data of the selected channel
English