Valves Condensate Tray Mounting; Electrical Connections - Mark TANNER CLA Livret Technique

VALVES CONDENSATE TRAY MOUNTING (optional)
The auxiliary tray collects the condensate formed near the water connections and the
valves.
Fix the tray to the structure with the screws provided in the position shown in Fig. H.,
making sure pipes and insulation do not tilt it, hindering the drain.
TYPE 070/090/094
Fig. H
EN
TYPE 150/154
Fig. H

ELECTRICAL CONNECTIONS

The electrical connections must be performed by specialists, according to the
National electrical standards in force.
Before making any connection the power must be turned off.
Use the appropriate wire gauge to the maximum drawn current as shown on the label of
the technical data on the unit.
Insert the wires from the grommet, placed in the corner of the structure, and lay them up
to the terminal as described in Fig. 1.
Fig. I
TYPE 150/154
TYPE 070/090/094
Connect respecting the instructions given in the scheme attached, according to the unit
typology and accessoires.
After the wiring, the wires must be securely fixed to the structure to prevent jamming
during the maintenance operations to adjacent devices.
The incorrect connection and/or the failure to respect the national regulations
void the guarantee and any other responsibility of the manufacturer.
7