Installation - Mark TANNER CLA Livret Technique

Installation

- Fix the unit on a ceiling or a solid support without vibrations.
- Do not install the appliance in a space exposed to sunlight or heat sources, vapor or
flammable gas.
- Install the cassette so that the inlet and outlet air ducts are not obstructed; the air must
circulate freely throughout the area that has to be air-conditioned.
- Install the device in an easily accessible place, so that there is no disruption during
maintenance.
UNIT FIXING
The location of the cassette installation must be chosen so that all around the unit
perimeter there is a space of at least 100 cm existing system (electrical or hydraulic). The
machine must be fixed to the ceiling by the means of threaded rods with anchors adjusted
according to the type of structure (to be provided by others) as described:
- the 4 hole positions in the structural ceiling must first be marked and the holes for the
threaded rods must then be drilled (the dimensions are shown by fig. A);
- the threaded rods must be securely fixed in the ceiling (their lenght depends on the
distance between the ceiling and the structural ceiling);
- the unit must be lifted inserting the threaded rods in correspondence with the fixing
slots and then blocked, using adequate washers and nuts (the arrangement is shown in
fig. B);
- verify, using a spirit level, that the machine is perfectly horizontal and then fix the nuts
and locknuts.
TYPE 070/090/094
Fig. A
TYPE 150/154
Fig. A
4
WASHER
Fig. B
WASHER
Fig. B
NUT
NUT