Getting Started - Ribimex Ribitech PP121 Manuel D'instructions Et D'utilisation

Wear protective helmet, safety goggles, ear mufflers, face or dust mask, rubber gloves and non-skid
footwear to reduce the risk of personal injury during product use or manipulation.
9. Do not overreach
Keep proper footing and balance at all times during product use or manipulation.
10. Maintain product with care
Keep product clean for better and safer performance.
11. Stay alert
Watch what you are doing. Use common sense.
Do not operate product when you are tired, under the influence of alcohol, prescription medicines
or drugs.
12. Check damaged parts
Before further use or reuse of the product, it should be carefully checked to determine that it will
operate properly and perform its intended function.
13. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
14. Have your product repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part
in an authorized service centre is recommended.
15. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
2.3- Specific instructions for use
1. The use of this product by children is forbidden.
2. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
III. GETTING STARTED
3.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
3.2- Assembly
3.2.2- PP121
1) For proper installation of the protrusion bar,
follow instructions as shown Fig.3.
2) When mounting the hoist, make sure to use
the rubber blocks to avoid slippage of the
bracket on the protrusion bar..
Fig.3