Genie Hand TLS Serie Mode D'emploi page 3

Watch the video instructions, it will guide you step by step
Geniehand.com/instructions
Preparing your time lock safe
1. Plug in the safe, if your safe has a power supply (Wired Safe Only).
2. Insert the batteries in the safe slot.
3. Reset the safe code by pressing the red button inside the safe, in the internal part of
the door, dial the new code on the keypad outside (3 to 8 numbers) and confirm it by
pressing E.
OPERATING MODES (fig.1)
1. Time Lock Safe mode.
Press the MANUAL button, there is a line on the lower part of the display going from ON to
AUTO to OFF and then back, set the Timer to AUTO to use it as a Time Lock Safe. With this
setting you will be able to open your safe with the keys and a correct code in the preset time
frames (between the ON and OFF time) (fig1).
2. Electronic mode.
Press the MANUAL button and set the Timer to ON to use it as a Standard Safe. This way you
are able to open it at any time, with the keys or a correct code, with no regards to the setting
of the timer.
3. Mechanical mode.
Press the MANUAL button and set the Timer to OFF to use it only with the keys.
The red led light on the timer is not steady but blinks in this battery-operated model.
AUTO MODE (Time Lock Mode)
g. 1
g. 2
3