HSW Henke Sass Wolf Vet-line ECO-MATIC Mode D'emploi page 5

5) FILLING OF THE ECO-MATIC
1. Remove protection cover of the needle.
2. Hold the ECO-MATIC
avoid suck in of air into the barrel.
3. Squeeze adjustable handle and then release quickly to draw fl uid into the barrel.
4. To remove air bubble inside the barrel, repeat step (c).
5. To fi ll th syringe and prepare for injection please make sure that the syringe is adjusted on
volume, 0,3 ml (for 0,3 ml syringe) or 0,5 ml (for 1ml syringe) to prime and that no air bubbles
are visible. Hold the syringe upright and squeeze the plunger so that air bubbles can be
released. From now on any dosage will be possible.
grip hollow
spike
viewing window
INSTRUCTION AFTER USE OF THE ECO-MATIC
Remove all traces of material from syringe by fl ushing thoroughly with a hot water detergent mix.
Rinse thoroughly with clean, warm water.
DISINFECTION
It is recommended that the ECO-MATIC
after each use.
1. Suck "hot" water into the barrel by using an attached bottle with warm water.
2. Suspend the complete ECO-MATIC
for up to 20 minutes.
3. Remove the ECO-MATIC
TO LUBRICATE:
Remove plastic barrel from the handle by turning it. Lubricate piston and glass barrel with 100% pure oil,
cold squeezed or equivalent vegetable oil.
Please follow the manufacturers durability and storage life instruction.
Do not use mineral oil, silicone, WD-40, glycerine or alcohol. Petroleum based products harden the piston,
reducing the life of the component.
®
®
at a slight incline and take care that the spike is below the liquid to
®
and a supply of needles or nozzles be disinfected before and
®
including needles or nozzles in a container of water and boil
®
from container, wrap cloth around the handle and pump it dry.
®