Roco Plux 16 Mode D'emploi page 6

1. Press the STOP and GO keys simultaneously until a reset is carried out
STOP key to deactivate the track voltage
2.
3. Enter address 80
Press the direction of travel changeover switch and keep it pressed in, then additionally press
4.
GO for min. 0.5 sec. so as to reactivate the track voltage
5.
The decoder is in programming mode = slow flashing
6. Enter the register which is to be changed (two-digit in the address field)
7.
Confirm by pressing the direction of travel changeover switch = rapid flashing
8. Enter the required value (two-digit in the address field)
GB
9.
Confirm by pressing the direction of travel changeover switch = slow flashing
Repeat 5-9 is additional CVs are to be programmed.
If the programming is to be terminated, set the unit to "STOP" or enter the address "80" before briefly confir-
ming the direction of travel change.
As only entries of 01 to 80 are possible when programming using a Motorola** digital unit from Märklin*, the
value "0" has to be entered as "80" above the address.
Programming instructions for the Märklin* "Mobile Station" and "Central Station"
 No locomotives are to be on the track with the exception of the locomotive which is to be programmed!
1. Press the ESC key
2. Select the "New Loc" menu item
3. Select the "Database" menu item
4. Select the article number "36330" with the rotary knob
5.
Press the ESC key on the Mobile Station again
6. Select the "change Loc" menu item
7.
The Märklin* address can be selected in the "Address" menu item
8. The locomotive name can be changed in the "Name" menu item
The functions F1- F4 can be called up with the 4 left keys on the Mobile Station. The top key hereby corres-
ponds to function F1. The activated functions cannot be shown on the display however.
Should the programming also fail after a second attempt by way of exception, please reset the decoder
either by programming CV08 with the value 08 or CV59 to the value 01!
Changing parameters with DCC systems
If you have a DCC-compatible digital system, you can change the CVs much faster and more comfortably.
Please read the appropriate chapter (programming of DCC decoders for example) in your manual. The decoder
recognises all of the NMRA programming methods.
Decoder reset
You can reset to the works settings at all times should you be lost: program the value 08 in CV 8.
6