Operation; Indicator Lights - Dometic GROUP Sealand VacuFlush 4800 Série Mode D'emploi

Operation

6.3 Changing flush modes
SeaLand 4800 series VacuFlush toilets offer two flush settings to help manage water consumption:
Normal flush – Uses 1 quart (0 .95 liter) per flush . Adds water to bowl after every flush .
Dry Bowl flush – Uses 1 pint (0 .5 liter) per flush . Does not add water to bowl after flush .
To change from Normal to Dry Bowl flush setting, press "Flush" switch for about five seconds . When
green "OK to Flush" light (3) on status panel begins flashing, release "Flush" switch . Flush mode has
been changed to Dry Bowl setting . Change mode to Normal flush by following the same procedure .
6.4

Indicator lights

"OK TO FLUSH" INDICATOR
On the Dometic, Vimar and Gewiss status panels, a steady green "OK to Flush" light indicates when
the toilet is ready to flush . A momentary flashing green light indicates when flush mode is changing .
"DO NOT FLUSH" INDICATOR
The Dometic, Vimar and Gewiss status panels include a red "Do Not Flush" light to indicate two toilet
system conditions:
1 . vacuum level in toilet system is not sufficient for complete flush .
2 . holding tank is full and should be pumped out . When the red light is on, electrical power to the
toilet automatically shuts off to prevent possible overfilling of the holding tank .
6.5 Service mode
To clean the toilet bowl or perform other service that
requires keeping the flush ball open without running
water, locate the Service Mode switch (fig .
2) at the back left side of the seat bracket .
1 . Slide the switch to the right . (On some models
the Service Switch is a toggle-type that's located
on the check valve of the toilet . It can be reached
behind the left side of the toilet bowl .)
2 . Perform the service operation . To close the flush ball and return to Normal operation, slide the
Service Mode switch to the left .
6.6 Bidet operation
Applies to 4800 series VacuFlush
toilet/bidet combination models only .
1 . Turn on bidet faucet by turning
handle away from toilet (fig .
2 . Adjust water temperature by turning
handle up for warm water and down
for cool water (fig .
3 . Use electronic "Flush" switch to clear
toilet bowl during and after bidet use .
Caution! Hazard of Flooding
Be sure to shut bidet faucet off completely after use .
8
5 ) .
6 ) .
SeaLand 4800 Series VacuFlush Toilet
1, page
1
5
SERVICE MODE
Switch behind seat
6
.