Maintaining - Blumfeldt 10030007 Mode D'emploi

A Maintaining water
1. Clean your filter cartridge at least once a time after it worked continuously for 72- 120
hours. The filter cartridge should be replaced at least once a month depending on use.
2. Change water every few days or use appropriate pool chemicals. All spas require
the use of pool chemicals. Please consult your local pool supply retailer for more
information about chemical maintenance. Pay close attention to the chemical
manufacturer's instructions. .
Spa damage resulting from misuse of chemicals and mismanagement of spa water is
not covered by the warranty.
• Water balance; we recommend maintain your water PH between 7.2 and 7.8, total
alkalinity between 80 and 120ppm and free chlorine between 3 to 5ppm.
• Purchase a test kit to test your water chemistry before each use of the spa, no less
than once per week. Low PH will damage to the spa and pump. Damaged resulting from
chemical imbalance is not covered by the warranty.
• Water sanitation is the responsibility of the spa owner, achieved through the regular
and periodic (daily, if necessary) addition of an approved sanitizer. The sanitizer will
chemically control bacteria and viruses present in the fill water or introduced during use
of the spa.
B Fleaning the filter cartridge
1. Make sure to unplug the power pack from the electrical receptacle before the following
actions.
2. Unscrew the filter cartridge by turning counterclockwise.
3. Remove the filter cartridge cover.
29

Maintaining