Blumfeldt 10030007 Mode D'emploi page 25

4. Inflate the spa tub by pressing the "Jet" button.
When the spa is properly inflated, press the "Jet" button to shut off the bubbles.
• Do not over inflate.
• If you want inflation when the spa has filled water, you must put on the Jets 2-3 minutes
by pressing the "Jet" button first, and then operate according to step 2-5 above.
5. Remove the inflation hose and screw the valve tight.
6. Remove the inflation hose from the air outlet and screw the nut tight.
7. Screw the filter cartridge onto the water inlet on the spa wall by turning it clockwise.
8. Fill the spa using a garden hose to fill to the water level printed on the spa wall.
9. Place the cover onto the spa, fasten the zipper.
25