Before You Begin - GE Profile PWS06D Serie Manuel Du Propriétaire Et Instructions D'installation

Installation
Instructions and Wine Chiller
Questions? Call 800.GE.CARES (800.432.2737)
GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and
carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
WARNING
• This appliance must be properly
• If you received a damaged beverage center or
wine chiller, you should immediately contact your
dealer or builder.
• Skill Level – Installation requires basic
mechanical skills. Proper installation is the
responsibility of the installer. Product failure due
to improper installation is not covered under the
GE Appliance Warranty.
DOOR SWING
The door swing on this product is not reversible.
TOOLS REQUIRED
• #2 Phillips screwdriver
• 10mm Hex nut driver
49-1000514 Rev. 1
Beverage Center
Save these
Observe all
Be sure to leave these
or
PRODUCT CLEARANCES
The beverage center and wine chiller is factory set
for a 125° door swing.
When installed in a corner:
90° door swing and to allow racks to slide out.
a full 125° door swing.
16" Minimum
to Wall
125°
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the door.
•
will go below 55°F (19°C) because it will not run
often enough to maintain proper temperatures.
•
will go above 90°F (35°C) because it will not
perform properly.
•
to water (rain, etc.) or direct sunlight.
• These products are not designed to be stacked
one over the other.
21-1/4"
24"
90°
4" Minimum
to Wall
11