Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
WARNING –
•
properly grounded. See "Electrical Supply."
• If you received a damaged beverage center or wine
chiller, you should immediately contact your dealer
or builder.
• Skill Level – Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
WARNINGS:
• Use this appliance only for its intended purpose.
• Immediately repair or replace electrical service cords that
become frayed or damaged.
• Unplug the unit before cleaning or making repairs.
• Repairs should be made by a qualified service technician.
Save these instructions
Observe all governing
Be sure to leave these
Keep these instructions
This appliance must be
Beverage Center
and Wine Chiller
or
Visit our Website at:
PRODUCT CLEARANCES
The beverage center and wine chiller is factory set for a
110° door swing.
When installed in a corner:
• Allow 4" min. clearance on the hinge side for the 90° door
swing and to allow racks to slide out.
• Allow 10" minimum clearance on the hinge side for a full
110° door swing.
10" Minimum
to Wall
110°
• The door swing is reversible on all models. If desired,
change the door swing before installation.
Choose the location:
• These products may be closed in on the top and three
sides as long as the front is unobstructed for air circulation
and proper access to the door.
• Do not install these products where the temperature will go
below 55°F (13°C) or above 90°F (32°C).
• Do not install where it will be subject to direct sunlight, heat
or moisture.
• These products are not designed to be stacked one over
the other.
8
ge.com
90° Door Swing
90°
4" Minimum
21-5/8"
23-5/8"
to Wall