Measurement Modalities; Downloading The Application; Getting Started - bewell connect MyTensio BW Manuel D'utilisateur

4-5. MEASUREMENT MODALITIES

See Diagram B on page 2
Do not take measurements over clothing. Remove all jewelry on the arm to be measured before use
(watch, ring, bracelet, etc.).
- Make sure you have a smartphone or tablet with the BewellConnect® application installed
at hand.
- With the palm of the hand facing upward, thread the cuff so that the display screen of the
monitor is pointed toward you in the reading direction.
- The cuff must be one or two centimeters from the palm.
- Wrap the cuff comfortably around the wrist, both edges of the cuff should be tightened at
the wrist and forearm.
- When the cuff is positioned correctly, hold it in place by pressing the tab firmly against
the velcro.
- Press the ON/START button to turn the monitor on. The blue LED will light up.
- Place your arms on the table, palm up, so that the monitor is at heart level.
- Sit on a chair with your feet flat (do not cross your legs), place your arm on the table, palm
upward. The cuff should be at the same level as your heart. The heart is located slightly
below the armpit. In the event of difficulties in positioning your wrist at heart level, use a
support under your arm.
- Sit quietly for two minutes before the blood pressure measurement.
Note: For a better interpretation of the results, always take measurements using the same arm.

4-6. DOWNLOADING THE APPLICATION

The following information is subject to change.
Download the BewellConnect® application on your smartphone or tablet:
- Through the app store or Google Play
- Or by scanning the QR code on the side of the box.
bw
M y
Then click on the MyTensio icon.

4-7. GETTING STARTED

- Position the monitor as explained in Chapter 4-6.
- Launch the BewellConnect® application and click on MyTensio.
- Hit START on the screen (application) to start the measurement.
- The cuff will inflate automatically. The 3 blood pressure readings in a row are taken auto-
matically. The cuff inflates and deflates 3 times, following the procedure in the MyTensio
application. Do not remove the cuff before the end of the 3 readings. The readings are sent
automatically to the application via Bluetooth 4.0.
BewellConnect - BW-BW1 - User Manual - 022017v1 13