Quick-Start Sauna Operation; Quick-Start Steam Operation - Karibu Modern Bio Mode D'emploi

Operating instructions for the user - Figure 5
6 Quick-Start
Sauna Operation
6.1 Turning on the control
Turn on the control according to chapter 5.1.
6.2 Sauna Operation
1. Set the desired temperature using the knob 4.
Note (with a pencil mark) the temperature most
agreeable to you.
2. Briefly press time key 9 (less than 2 seconds)
• The heater starts.
• The signal lamp 2 is lit constantly.
If the cabin temperature measured is less than the
desired temperature set, the stove will respond. The
stove will heat.
If the cabin temperature measured is greater than the
desired temperature set, the stove will not respond.
6.3 Turning off the control
Turn off the control according to chapter 5.2.
7 Quick-Start
Steam Operation
7.1 Turning on the control
Turn on the control according to chapter 5.1.
7.2 Steam Operation
Steam operation at temperatures below 65°C
only:
Refer to chapter 1 Operating Modes.
1. Using the knob 4 set the desired temperature at
a range 5 of 40°- 65°C.
Note (with a pencil mark) the temperature most
agreeable to you.
2. Set the desired steam output using the knob 6.
Note (with a pencil mark) the steam output most
agreeable to you.
3. Briefly press time key 9 (less than 2 seconds)
• The heater starts.
• The steam generator starts to work.
• The signal lamp 1 is lit continually.
The steam output is implemented by quickly turning
on and off the steam generator. The time for turning
the steam generator on and off depends on the level
of steam output selected.
7.3 Turning off the control
Turn off the control control according to chapter 5.2.
• 23 •