Weekly Service - Huffy 28411 Mode D'emploi

MAINTENANCE
The scooter should be checked periodically for any loose, broken, or worn parts . Tighten any
parts that are loose, and replace any worn or broken parts immediately . Periodic cleaning
will prolong the useful life of this scooter .
SELF-LOCKING FASTENERS:
With repeated use, Self-Locking Fasteners may loose their ability to lock to the threads and
may come loose . Frequently check Self-Locking Fasteners and replace when worn .
INSPECTION OF THE BEARINGS:
Frequently check the wheel bearings of the product . Replace the wheels when the bearings
do not pass the following tests:
Lift each end of the product off the ground and spin the raised wheel by hand:
• The wheel should spin freely and easily .
• There should be no side-to-side movement at the wheel edge when pushed to the side
with light force .

WEEKLY SERVICE:

Apply a few drops of general purpose oil to the sides of each wheel axle . Verify that the axle
fasteners are tight .
Torque Table - Recommended Torque:
Use of a torque wrench is recommended .
Recommended torque for each fastener is
listed below . In addition to tightening to
the recommended torque, please ensure
the parts of the product are suffi ciently
tightened by performing the functional tests
(in the component assembly sections of the
Recommended Torque for clean, dry threads:
Fastener Size
.157 in (4 mm)
.196 in (5 mm)
.236 in (6 mm)
.275 in (7 mm)
.314 in (8 mm)
.393 in (10 mm)
Torque (ft-lb / N•m)
3 .1 ft-lbs (4 .2 N•m)
5 ft-lbs (6 .8 N•m)
7 ft-lb (9 .5 N•m)
12 ft-lbs (16 .3 N•m)
17 ft-lbs (23 N•m)
33 ft-lbs (44 .7 N•m)
owner's manual) on each component as it is
tightened .
NOTE:
Please check that all fasteners on the
product are torqued according to the table
below:
How to Measure:
Screw or bolt size is determined by the
width at the THREADS as shown .
13