WATSEA TOP FLOW Mode D'emploi page 7

Pump Structure Diagram:
1. Pump cover
2. Impeller cover
3. Outlet
4. Impeller
5. Pump body
6. Rubber section cup
7. Rotor
8. Casing
9. Power cord
Thermal Overload Protection:
This pump is configured with thermal overload 'self-reset' protection. If the motor overheats, the witch
will activate & cut off the power automatically. If this occurs, switch the pump off at its main power
supply. Then check for the pump for debris blocking the inlet/outlet of the pump or the impeller.
Remove the obstruction, check the electric cable & wait for 15 minutes. When the motor has cooled
down, the thermal overload switch on the pump will reset. You can then switch on the pump (at the
power source) & it should start to work again.
Monitor the pump for a few minutes to ensure it does not cut off again. If the problem persists, return
6