Humminbird HELIX 5 Serie Mode D'emploi page 2

HELIX® 5 Series In-Dash Mounting Installation Guide
3. Using the template, select the cutting method that is best for your boat:
• Drill one entry hole away from the main cut line that is large enough to insert the blade of your cutting tool.
OR
• Drill a corner hole away from the main cut line using a drill bit that will create a hole as close to a diameter
of .42 inches (10.7 mm) as possible. Repeat for the other three corners as indicated on the template. Use
one of the corner holes as an entry hole, or drill an additional entry hole away from the main cut line.
4. Carefully begin cutting toward the cut line, and continue cutting to the inside of the line around the
template.
5. Test the Mounting Hole: Install the control head in the mounting hole to test the fit. Make adjustments
to the mounting hole as needed. Remove the template when finished.
6. Thoroughly clean and deburr the mounting hole.
3. Install the Control Head
1. Clean the Mating Surfaces: Use rubbing alcohol to clean the edges of the in-dash mounting hole and
the back rim of the control head where the gasket will be installed (see the illustration Installing the
Gasket). Allow the cleaned areas to dry completely.
2. Place the control head, with the screen facing down, on a towel or cloth on a stable and level surface.
3. Peel the brown liner from the adhesive backing on the gasket.
4. Hold the sides of the plastic film attached to the gasket with the adhesive side facing down (see the
illustration Installing the Gasket). Carefully align the gasket around the rim of the control head so it is
centered. Confirm there are no uneven gaps.
CAUTION! Use caution when handling the gasket. Do not allow the adhesive to touch the sides or rear of the
control head during installation.
5. Lightly press one side of the gasket down onto the flat rim of the control head.
6. Confirm the alignment has not changed and that the gasket is centered around the control head. Then
lightly press down on the remaining sides of the gasket. Make adjustments, as needed.
7. Carefully peel the plastic film from the gasket.
8. Insert the control head through the mounting hole from the front side of the dash. Press down firmly
around the sides of the control head for 20 seconds to secure the adhesive.
4. Route and Connect the Cables
1. See the installation guides included with each hardware component to install power and other optional
equipment.
2. Route all cables (power, transducer, accessories) to the control head and insert the connectors into the
correct ports on the back of the control head (see the illustration Connecting the Cables and Control
Head Ports).
CAUTION! Do NOT mount the cables where the connectors could be submerged in water or flooded. If cables
are installed in a splash-prone area, it may be helpful to apply dielectric grease to the inside of the connectors to
prevent corrosion. Dielectric grease can be purchased separately from a general hardware or automotive store.
Your control head is ready for on-the-water operation. See your control head operations manual for further
details.
2
532319-2_A
Installing the Gasket
Confirm the gasket is evenly centered
around the rim of the control head.
Install the gasket along the flat rim of
the control head (highlighted in grey).
Installing the Control Head
Connecting the Cables
Control Head Ports
COM
power (communications) transducer
Optional: Use a Y-cable to connect Transducer
and Speed Sensor Accessory