Workstation; Danger Zone - Rapid Technic MONDO 1550 Mode D'emploi

2.1

Workstation

2.2

Danger zone

EN
128
The workstation [A] is situated directly on the handlebar. The operator must not leave the
handlebar while working.
Working on even terrains and slopes with an inclination of up to max. 40%
The danger zone [B] is defined from the attachment as follows:
• 10 m to the front.
• 10 m to each side.
• to the rear up to the wheel axle of the machine.
Working on slopes with inclinations above 40% or on uneven terrain
On slopes with an inclination of more than 40% or on uneven terrain the machine may slip
or topple over thus increasing the original danger zone by the potential slipping and toppling
area of the machine [C].
For further information, see chapter 2.4.
If using attachments with a risk of projected parts, the danger zone of the device
manufacturer applies.
The machine may trap the user or third persons, cause them to fall over, run them over,
crush or lacerate them. Apart from this there is a danger of flying stones.
• The operator bears the full responsibility that there are no persons within the danger
zone.
• Should people or animals enter the danger zone, immediately release the dead man
handle. Only press the dead man handle back down again when the danger zone is free
of people and animals.
• Do not touch machine parts until they have come to a complete standstill (moving parts
continue to run).
A
+ 10 m
+ 10 m
B
C
Note
Danger
+ 10 m
Machine No. from 10005183