Assembly And Start-Up; Maintenance / Care - Würth 0891 900 500 Traduction Des Instructions De Service D'origine

Assembly and start-up

Attention!
¾ It is the responsibility of the fitter to ensure that
the assembly of the device complies with the
applicable regulations, standards and official
requirements.
¾ Do not install the dispenser above heat sources
or near to sources of ignition/flames.
¾ Do not install in locations where a defect to
the assembly system or the dripping of the
filling material from hands could cause device
damage or a safety risk.
Open device [Fig. II]
Open the housing by pressing the locking button
■
or use the key.
Assembly [Fig. III and IV]
Attach the dispenser to the wall rail (Fig. III) or
■
directly to the wall (Fig. IV). Use the enclosed
fixing materials for this purpose.
Pump [Fig. V]
Remove the lid vertically from the nozzle. Make
■
sure the position of the nozzle is the same as
depicted in the figure.
Insert container with pump [Fig. VI]
Place the pump into the container. Pay attention
■
to the position of the nozzle.
Operate dispenser [Fig. VII]
Close the dispenser.
■
To ensure that the pump is ready, operate the
■
dispenser multiple times.
8

Maintenance / care

Attention!
Risk of injuries or property damage due to
improper actions.
¾ Do not use any products with abrasive
ingredients.
Clean the dispenser housing with a slightly
■
moistened cloth.
Cleaning agents must be compatible with plastic
■
surfaces.
Do not use any products with abrasive ingredi-
■
ents.
Sticky product residues must be removed regu-
■
larly.
Disinfecting the dispenser housing with appro-
■
priate surface disinfectant is possible.
Disposal
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your waste disposal
facility. Dispose of all packaging in an environmen-
tally compatible manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note). Damage that has
occurred will be corrected either by replacement or
by repair. Damage caused by improper handling is
not covered by the warranty. Claims under warranty
can only be accepted if the device is returned fully
assembled to a Würth agency, your Würth sales
representative or an authorised Würth customer
service workshop.
Subject to technical changes without prior notice.
We accept no liability for printing errors.