Servicing - Summit GCJ1SS Manuel De L'utilisateur

Masquer les pouces Voir aussi pour GCJ1SS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Always disconnect the appliance from the electric and gas supplies before proceeding with any
servicing operation.
Replacing Components
To replace the components housed inside the appliance, remove the trivets and the burners
from the upper part of the cooktop. Remove the fixing screws "V" of the burner (Fig. 13) and the
knobs using hand pressure to remove them from the appliance.
After having carried out these operations, the burners (Fig. 14), taps (Fig. 15) and electrical
components can all be replaced (Fig. 16).
It is advisable to change seal "D" (Fig. 15) whenever a tap is replaced to ensure a perfect
tightness.
Greasing the Taps
If a tap becomes stiff to operate, it must be greased immediately in compliance with the following
instructions:
1. Remove the tap.
2. Clean the cone and its
housing using a cloth
soaked in solvent.
3. Lightly grease the
cone.
4. Fit the cone back into
place, operate it a few
times and then remove
it again.
5. Eliminate any excess
grease and check that
the gas ducts have not
become clogged.
6. Fit all parts back into place, following the disassembly order in reverse.
7. The tight closure test must be done using a foaming liquid.
NOTE: Never use a flame for this test.

SERVICING

19

Publicité

Chapitres

Table des Matières
loading

Table des Matières